Accessories
Fittings, Faucets and other Addons/Accessories.
Please Note: The thread fittings are not outer diameter measurements, the outer diameter measurement for 3/8" is 16.4mm.
JACO 1/4" Tube to Standard 1/4" Male
Please Note: The thread fittings are not outer diameter measurements, the outer diameter measurement for 1/4" is 12.9mm.
Tee 1/4" (6mm) Tubing on side and 1/4" Spigot in middle.
Spigot's can be pushed into other Quick Connect fittings.
Blue retaining clip included but not shown in image.
Used for only allowing water to flow in one direction.
1/4" Tubing or 3/8" Tubing is connected on both ends.
Quick Connect 1/4" Tube to 1/4" Thread (Male).
Please Note: The thread fittings are not outer diameter measurements, the outer diameter measurement for 1/4" is 12.9mm.
Male to Female Chrome Plated Brass Adapter
1/2" Male to 1/2" Female with 1/4" Side Port for Ball Valve.
Shortest Length, may differ slightly to image.
Description is in the product name, no additional information is available at the moment.
Please contact us if you have any questions about this product.
Tee Piece with JACO fittings around.
For use with under-counter and RO systems.
A hole must be drilled through the counter for mounting.
Used to tighten and loosen filter housing when replacing membranes.
For use with under-counter and RO systems.
A hole must be drilled through the counter for mounting.
Note: Flow rate is faster with the elegant faucet.
JACK 1/4" Fitting with Elbow to 1/4" Thread (Male)
Please Note: The thread fittings are not outer diameter measurements, the outer diameter measurement for 1/4" is 12.9mm.
JACO 3/8" Tubing with Elbow to 1/4" Thread (Male)
Please Note: The thread fittings are not outer diameter measurements, the outer diameter measurement for 1/4" is 12.9mm.
*Image is stock image of 3/8" to 3/8".
For use with under-counter and RO systems.
A hole must be drilled through the counter for mounting.
This system works with any 10" Single, Dual or Triple Stage Under-Counter Filtration System or RO (Reverse Osmosis) System.
Standard 1/4" Inlet and Outlet.
The leaked-water accumulates in the holding tray and triggers shutoff of the supply.
*Does not include the RO system shown in the image.
Video Demonstration:
Used to tighten and loosen filter housing when replacing cartridges.
Male to Female Chrome Plated Brass Adapter
3/4" Male to 3/4" Female with 1/4" Side Port for Ball Valve.
Short Length.
Image shows 1/2" but the product is actually 3/4 Inlet-Outlet"
Used directly on copper pipe to attach 1/4" tubing for RO or under counter filtration systems without needing to cut the copper pipe or use additional tools or fittings.
The clamp is secured around the copper pipe and a needle-like fixture pierces the copper pipe to allow the water to flow out the 1/4" adapter where 1/4" tubing is attached.
The faucet can be turned to shut off flow also functioning as a shutoff valve.
Fits both 15mm and 22mm copper pipes.
*actual product may differ slightly to image.
Quick Connect 1/4" Tube to 1/4" Tube Straight Connector / Coupler.