Search
Search Criteria
Products meeting the search criteria
Industrial Ultra-filtration membrane system. Removes particles larger than ~0.01um.
Add to Cart
R10,046.40
End Cap for 2540 Stainless Steel RO Housing (RO-MH2540SSEC)
RO MEMBRANE HOUSING STAINLESS STEEL PLASTIC END CAP FOR 2540
Cap only which includes 2 rubber seals.
Image shown is a 4040 end cap for illustration only.
Cap only which includes 2 rubber seals.
Image shown is a 4040 end cap for illustration only.
Replacement End Cap
Add to Cart
R393.30
Ball Valve 1/4" Thread to Tube 3/8" S/Steel (BV-38)
Stainless Steel Ball Valve
1/4" Male Thread to 3/8" (9.5mm) Tubing
Typically used with ball valve adapters when installing point of use filtration systems such as under-counter units and reverse osmosis units.
Add to Cart
R69.00
Ball Valve 1/4" Thread to Tube 1/4" S/Steel (BV-14)
Stainless Steel Ball Valve
1/4" Male Thread to 1/4" (6mm) Tubing
Typically used with ball valve adapters when installing point of use filtration systems such as under-counter units and reverse osmosis units.
Add to Cart
R69.00
End Cap for 4040 Stainless Steel RO Housing (RO-MH4040SSEC)
RO MEMBRANE HOUSING STAINLESS STEEL PLASTIC END CAP FOR 4040
Cap only which includes 2 rubber seals.
May differ from image due to multiple suppliers.
Cap only which includes 2 rubber seals.
May differ from image due to multiple suppliers.
Replacement End Cap
Add to Cart
R239.57
Ultrafiltration System 4040 Stainless Steel 4000LPH (UF-4040SS)
Industrial Ultra-filtration membrane system. Removes particles larger than approximately 0.01um. Requires pre-filtration or will block up quickly.
Note: These specs are tested under conditions of (1) stable water pressure (2) stable quality of feed water and Maintenance. Some of the performances may differ if not fulfilled the above conditions.
Clean water comes out the side port, either end is the inlet and the other end should be blocked off.
You cannot use UF without sufficient pre-filtration.
NOTE: These systems are rated at 4,000LPH however this depends on pre-treatment and having sufficient supply and pressure to provide 4,000LPH at 3BAR to the membrane, from our own experience without supplying 4,000LPH at 3BAR with adequate pre-filtration you will not receive this volume and may need more units in parallel configuration to achieve this.
Manual (191KB)
- Maximum feed pressure ( Mpa ) 0.3
- Admission Transmembrane Pressure ( MPa ) 0.3
- Normal operation pressure ( MPa ) 0.1 ~ 0.3
- Backwash pressure ( MPa ) 0.1
- Ph value of feed water 2 – 10
- Chlorine of feed water (mg/L) < 3
- Operation mode Dead end or Cross-flow
- Max operating temperature < 45°C
- Membrane characteristics Hydrophilic Double Skin
- Hollow-fiber membrane material Polyacrylonitrile (PAN) Modified
- MWCO (Dalton) 50,000
- Membrane area (m2) 5
- In & out water caliber of membrane module G 3/4”
- Max Air Pressure for integrity test (MPa) 0.2
- Flux (0.1MPa, 25° C) 4000 Liters /Hour
- Material of Cartridge ABS
- Weight of Cartridge with hollow fiber <15KG
- Time to change cartridge 1-2 years
- Material of cylinder housing Stainless Steel 304
- Thickness of housing 1.5 mm
Note: These specs are tested under conditions of (1) stable water pressure (2) stable quality of feed water and Maintenance. Some of the performances may differ if not fulfilled the above conditions.
Clean water comes out the side port, either end is the inlet and the other end should be blocked off.
You cannot use UF without sufficient pre-filtration.
NOTE: These systems are rated at 4,000LPH however this depends on pre-treatment and having sufficient supply and pressure to provide 4,000LPH at 3BAR to the membrane, from our own experience without supplying 4,000LPH at 3BAR with adequate pre-filtration you will not receive this volume and may need more units in parallel configuration to achieve this.
Manual (191KB)PLEASE BE ADVISED THIS ITEM IS ON BACK ORDER AND WE DO NOT HAVE AN ETA AS OF YET.
Industrial Ultra-filtration membrane system. Removes particles larger than ~0.01um.
Add to Cart
R10,046.40
Stainless Steel RO Membrane Housing (4040) (RO-MH4040S)
Stainless Steel Membrane Housing for Size 4040 Reverse Osmosis Membranes.
Technical information available on request.
Empty 4040 housing.
Add to Cart
R3,427.00
Clamp for 4040 Stainless Steel RO Housing (RO-MH4040SSCL)
RO MEMBRANE HOUSING STAINLESS STEEL CLAMP FOR 4040
May differ from image due to multiple suppliers.
May differ from image due to multiple suppliers.
Replacement clamp.
Add to Cart
R345.18
- 1